Chery A21 2005 Service Manual page 194

II. DISASSEMBLING THE TAIL LIGHT
ASSEMBLY
1. Remove the luggage compartment wheel
house trim assembly and the floor mat;
Assembly requirements: The contact part of
the carpet circumference and the luggage
compartment
wrapped into the lip of the weather strip with
good matching. The contact part of the carpet
circumference and the C pillar upper cover
sheet should be placed inside the cover sheet.
All parts should be installed in place and in
perfect joint with the body. The luggage
compartment carpet clip should be just
placed into the room of the rear trim panel of
the luggage compartment. The two sides of
the carpet should be tightly stuck to the folds
of the left/right trim of the luggage
compartment wheel house and should be in
perfect joint with the rear floor of the body
after fitting.
2. Remove the tail light fixing bolts, pull out
the harness, and then detach the tail light;
A Brake Lamp/Side Light Bulbs: 12V 21W/
5W
B Turn, C Reversing, D Rear Fog Light
Bulbs: 12V 21W
PDF created with pdfFactory Pro trial version
Chery Service Manual for A520
weather strip should
Body Dimension and Accessories
be
15
www.pdffactory.com
Figure 35
Figure 36
A
B
C
D
Figure 37