Chery A21 2005 Service Manual page 54

7) Check the cylinder block
a: Check whether there is scuffing or piston
scraping on the cylinder wall. If the
defect
cylinder or and set with bushing or
replace it.
b: Use cylinder gauge to measure the inner
diameter and cylindericity.
Cylindericity
Cylindericity=max. cylinder diameter-min.
cylinder diameter.
Measure the cylinder diameter in the A and B
directions, and calculate the cylindericity in
the two directions and select the max value.
3.2.3 Installation
1) Apply oil onto the piston pin and in the
piston pin hole, and use piston pin to
connect the piston with the connecting
rod, and then mount the piston pin
circlip.
2) Mount piston ring. Mount all the rings
onto
sequence: the bushing ring of oil control
ring upper and lower blades, second air
ring, first air ring. Observe the piston
ring direction when mounting various
rings: those with "TOP" onto it shall be
positioned upwards. Form an angle by
crossing the two blades and the bushing
ring, with the closed angle at the
bushing ring joint pointing at the piston
top, and the first ring and second ring
intersecting with the blades for 1200.
PDF created with pdfFactory Pro trial version
exits, please dissection
Standard value
the piston according
the
12 mm
Center
Bottom
Limit
value
to the
45
www.pdffactory.com