How Not To Store A Reading; How Do I Evaluate My Blood Pressure; Data Memory; Viewing The Stored Values - Microlife BPA7 Touch BT Manual

reached, the device will automatically pump some more air into
the cuff.
6. During the measurement, the pulse indicator BR flashes in the
display.
7. The result, comprising the systolic AP and the diastolic AQ blood
pressure and the pulse rate AR are displayed. Note also the
explanations on further display symbols in this booklet.
8. When the device has finished measuring, remove the cuff.
9. Switch off the device. (The monitor does switch off automati-
cally after approx. 1 min.).

AF detection is only activated in AFIB/MAM mode.

You can stop the measurement at any time by pressing the
ON/OFF button or open the cuff (e.g. if you feel uneasy or
an unpleasant pressure sensation).

This monitor is specially tested for use in pregnancy and
pre-eclampsia. When you detect unusual high readings in
pregnancy, you should measure after a short while again
(eg. 1 hour). If the reading is still too high, consult your
doctor or gynecologist.

In pregnancy the AFIB symbol can be ignored.

How not to store a reading

As soon as the reading is displayed press and hold the START/
STOP button 1 until «M» AO is flashing. Confirm to delete the
reading by pressing the M-button AO.

«CL» is displayed when the reading is deleted from the
memory successfully.

How do I evaluate my blood pressure

The LED traffic light indicator on the left-hand side of the display
AP indicates within which range the measured blood pressure lies.
The value is either within the optimum (green), elevated (yellow) or
high (red) range. The classification corresponds to the following
ranges defined by international guidelines (ESH, ESC, JSH). Data
in mmHg.
Range Systolic Diastolic Recommendation
1. blood pressure ≥135
too high
2. blood pressure 130 - 134 80 - 84
elevated
Microlife BP A7 Touch BT
≥85 Seek medical
advice
Self-check
Range Systolic Diastolic Recommendation
3. blood pressure <130
normal
The higher value is the one that determines the evaluation.
Example: a blood pressure value of 140/80 mmHg or a value of
130/90 mmHg indicates «blood pressure too high».

5. Data memory

This device automatically stores up to 99 measurement values for
each of the 2 users and guest mode.

Viewing the stored values

Switch the lock switch 3 to «unlock» position. Select either user
1 or 2 with the user indicator BM. Press the M-button AO briefly. The
display shows an average value.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored
value to another.
Memory full

Pay attention that the maximum memory capacity of 99
memories per user is not exceeded. When the 99 memory
is full, the oldest value is automatically overwritten with
the 100th value. Values should be evaluated by a doctor
before the memory capacity is reached – otherwise data will
be lost.

Clearing all values

Make sure the correct user is activated.
1. Firstly unlock the device 3, then select either 1 or 2 with the
user indicator BM.
2. Hold down the M-button AO until «CL» appears and then
release the button.
3. Press the M-button while «CL» is flashing to permanently clear
all values of the selected user.

Cancel deletion: press START/STOP button AN while
«CL» is flashing.

Individual values cannot be cleared.
<80 Self-check
5
EN