Unpack And Mount An Ssr1400; Tools And Parts Required To Unpack The Ssr1400 Appliance; Unpack An Ssr1400 - Juniper SSR1400 Hardware Manual

Unpack and Mount an SSR1400

SUMMARY
Unpack the appliance using the recommended tools
and following the recommended procedure.

Tools and Parts Required to Unpack the SSR1400 Appliance

To unpack the appliance and prepare for installation, you need the following tools:
• Phillips (+) screwdriver, number 2
• A box cutter or packing knife to slice open the tape that seals the boxes

Unpack an SSR1400

The SSR1400 is shipped in a cardboard carton and secured with foam packing material.
NOTE: The SSR1400 is maximally protected inside the cardboard carton. Do not unpack it until
you are ready to begin installation.
To unpack the SSR1400:
1. Move the cardboard carton to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the SSR1400.
IN THIS SECTION
Tools and Parts Required to Unpack the
SSR1400 Appliance | 25
Unpack an SSR1400 | 25
Verify Parts Received with the
SSR1400 | 26
Install the SSR1400 in a Rack | 27
25