Removing The Ac Power Supply From An Ssr1400; Installing The Ac Power Supply In An Ssr1400 - Juniper SSR1400 Hardware Manual

Ensure that you have the following parts and tools available:
• ESD grounding strap
• Antistatic bag or an antistatic mat
• Replacement AC power supply

Removing the AC Power Supply from an SSR1400

To remove a power supply from the appliance (see
1. If the AC power source outlet has a power switch, set it to the off (0) position and pull out the power
cord connected to the power source outlet.
2. Place the antistatic bag or the antistatic mat on a flat, stable surface.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to
the ESD point on the chassis.
4. Pull the power cord retainer down and remove the power cord from the power supply faceplate.
5. Slide the ejector lever towards the right (see
unseated.
6. Grasp the power supply handle and pull firmly to slide the power supply halfway out of the chassis.
7. Place one hand under the power supply to support it and slide it completely out of the chassis. Take
care not to touch power supply components, pins, leads, or solder connections.
Figure 19: Remove an SSR1400 AC Power Supply
8. Place the power supply in the antistatic bag or on the antistatic mat placed on a flat, stable surface.

Installing the AC Power Supply in an SSR1400

To install an AC power supply (see
Figure 19 on page
Figure 19 on page
Figure 20 on page 50):
49):
49) until the power supply is
49