TVLogic F-7HS Operation Manual page 23

05 MENU OPERATIONS
[7] SYSTEM
SYSTEM
DEFAULT
LUMINANCE
INTERNAL PAT
DISPLAY ENABLE
ECO SAVING
AUTO COOL
POWER LED
EXTERNAL FAN
SW UPGRADE
PRESET SAVE
PRESET LOAD
VERSION
SERIAL NUM
• AUTO COOL
- If [AUTO COOL] is set ON, the brightness mode is
automatically changed to cool down the monitor
and protect the hardware when the internal
temperature is increased to the particular level.
- When the temperature detected on the main
board reaches 75°C (167°F), the MAX BRIGHTNESS
mode is automatically changed to INDOOR mode.
And, 'MONITOR TOO HOT' and 'CHANGE TO INDOOR'
warning signs appear on the screen alternately.
When these warning signs appear, the MAX
BRIGHTNESS mode cannot be selected.
- When the internal temperature detected on the
main board goes down to 64°C (147°F), the
warning signs disappear and the MAX BRIGHTNESS
mode can be selected.
F-7HS
OFF
+ 8
OFF
ON
ON
ON
ON
OFF
OFF
OFF
OFF
SW 23 FPGA 04 BD 01
M9270506
• POWER LED
- Used to turn on or off the Power LED on the back
of the monitor.
- [ON]: When the monitor power is on, the Power
LED on the back turns green.
- [OFF]: When the monitor power is on, the power
LED on the back turns off.
• EXTERNAL FAN
- When [EXTERNAL FAN] mode is set ON, the USB
port outputs the 5V power, which allows the
external fan attached on the monitor to receive
the power for the fan operation.
• S/W UPGRADE
- Used to upgrade the firmware using USB
(Thumb drive).
* See section "7. Other Functions -> [14] Firmware
Upgrade" for more information.
• PRESET SAVE
- Available values are from PRESET 01 to PRESET 04.
- Used to save the current settings in the PRESET
position.
• PRESET LOAD
- Available values are from PRESET 01 to PRESET 04.
- Used to load the settings saved in PRESET 01 to
PRESET 04.
• VERSION
- Displays current firmware version.
• SERIAL NUM (Serial Number)
- Displays the serial number of the monitor.
FHD Hight Bright Field Monitor
23