2N IP Solo Installation Manual page 55

Nametag Placing
Every intercom package includes a piece of transparent foil, which can be laser printed. Cut the
printed foil and insert the nametags in the buttons.
Nametag dimensions for button:
• 1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; -0.5 mm)

Caution
• The area where nametags are placed is called a wet zone. After heavy rain, water
can penetrate to the nametag. Water in this area does not affect the intercom
functionality in any way and evaporates soon.
• Always use waterproof foil (enclosed or other) for the nametags. Never use paper
or ink jet printing to avoid damage due to water leakage!
Nametag inserting/replacing:
1. Remove the frame.
2. Lift up the button door. The 5-button module buttons have just one door.
3. Remove the used nametag and insert a new one.
4. Close the button door.
5. Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A
• Screw the flush mounting frame in the upper and bottom parts.
Version B
• Hang the surface mounting frame on the hook in the upper part and then screw it tight in
the bottom part.
Installation manual 2N® IP Solo
55 / 74