Levitronix BPS-2000.1 User Manual page 5

System Name Article # Pump Head
BPS-2000.1 100-90479 LPP-2000.6 (High Flow)
BPS-2000.2 100-90480 LPP-2000.6 (High Flow)
BPS-2000.4 100-90482 LPP-2000.7 (High Pressure)
BPS-2000.5 100-90483 LPP-2000.7 (High Pressure)
BPS-2000.7 (ATEX) 100-90485 LPP-2000.6 (High Flow)
BPS-2000.8 (ATEX) 100-90486 LPP-2000.6 (High Flow)
BPS-2000.10 (ATEX) 100-90488 LPP-2000.7 (High Pressure)
BPS-2000.11 (ATEX) 100-90489 LPP-2000.7 (High Pressure)
Pos. Component
Pump Head
1a
"High Flow Profile"
Pump Head
1b
"High Pressure Profile"
2a Motor
2b Motor (ATEX)
Standalone
3a Controller
(User Panel)
Extended
3b Controller
(PLC and USB)
Pos. Component
Sensor Cable
MCAS-600.1-05 (0.5m)
Extension Adaptor
MCAS-600.1-30 (3m)
4a
Cable for Sensor (a) MCAS-600.1-50 (5m)
4b
MCAS-600.1-70 (7m)
and Power (b)
MCAS-600.1-100 (10m)
MCAS-600.3-05 (0.5m)
Extension Adaptor
MCAS-600.3-30 (3m)
5a
Cable for Sensor (a)
MCAS-600.3-50 (5m)
5b
MCAS-600.3-70 (7m)
and Power (b)
MCAS-600.3-100 (10m)
Pos. Component
6a Air Cooling Module
6b Air Cooling Module
7
Impeller Exchange Kit
(a-e)
8
Impeller Exchange Kit
(a-e)
9 Ex Cable
(a – f)
Sealing System
PL-4021-00, Rev02, DCO# 15-235
Controller
LPC-2000.1-01
LPC-2000.2-01
LPC-2000.1-02
LPC-2000.2-02
LPC-2000.1-01
LPC-2000.2-01
LPC-2000.1-02
LPC-2000.2-02
Table 1: Standard system configurations
Article Name Article #
LPP-2000.6 100-90418
LPP-2000.7 100-90419
LPM-2000.2 100-10050
LPM-2000.8 100-10060
100-30018
LPC-2000.1-01
(Supply and Enable
("High Flow")
connector included)
100-30019
LPC-2000.1-02
(Supply and Enable
(„High Pressure")
connector included)
LPC-2000.2-01
100-30021
("High Flow")
(Supply and PLC
connector included)
100-30022
LPC-2000.2-02
(Supply and PLC
(„High Pressure")
connector included)
Table 2: Specification of standard components

1: Kalrez is a registered trademark of DuPont Dow Elastomers
Article Name
Power Cable
MCAP-2000.1-05
MCAP-2000.1-30
MCAP-2000.1-50
MCAP-2000.1-70
MCAP-2000.1-100
MCAP-2000.3-05
MCAP-2000.3-30
MCAP-2000.3-50
MCAP-2000.3-70
MCAP-2000.3-100
Table 3: Specification of adaptor/extension cables
Article Name Article #
ACM-4.2 190-10139
ACM-4.3 190-10243
IEK-2000.1
100-90529
(for LPP-2000.7)
IEK-2000.2
100-90530
(for LPP-2000.6)
ACS-A.1
100-90292
(Roxtec)
Table 4: Specification of accessories
Standard
Motor
Firmware
E1.25
Adaptor/Extension (0.5 - 10m) cables according to Table 3 (position 4a
E1.48
and 4b) have to be ordered as separate article with specified length.
LPM-2000.2
E2.25
Certifications: CE, IECEE (CB scheme), ETL (NRTL) -> see Section 9.1
E2.48
Adaptor/Extension (0.5 - 10m) cables according to Table 3 (Position 5a
E1.25
and 5b) have to be ordered as separate article with specified length. ATEX
E1.48 LPM-2000.8
Cable Sealing System can be ordered according to Table 4 (Position 9).
E2.25 (ATEX)
Certifications: CE, IECEE (CB scheme), ETL (NRTL), ATEX and IECEx ->
E2.48
see Section 9.1
Characteristics Value / Feature
Impeller / Pump Housing PFA / PFA (wet parts)
PP + GF30
Reinforcing Housing
Sealing Ring / Fittings Kalrez
Max. Flow 140 liters/min / 37 gallons/min
Max. Diff. Pressure 4.2 bar / 61 psi
Max. Viscosity/Max. Density 80 cP / 1.8 g/cm
Max. Liquid Temperature 90
PFA / PTFE (wet parts
Impeller / Pump Housing
Sealing Ring / Fittings Kalrez
Max. Flow 80 liters/min / 21 gallons/min
Max. Diff. Pressure 6.9 bar / 100 psi
Max. Viscosity/Max. Density 100 cP / 1.8 g/cm
Max. Liquid Temperature 90
- ETFE (chemical resistant) coated Aluminum
Housing
- waterproofed (IP67 without connectors)
Cable / Connectors 2x 3m cables with FEP jacket / 2x circular (AMP types)
ATEX / IECEx Marking
Cable / Connectors 2x 3m cables with FEP jacket / 2x circular (M23, IP67)
1 x 200-240 V AC
Voltage / Current / Power
3 x 200-240 V AC
See Section 3.2 for details.
IP20
Housing Protection
Panel to set speed (automatic storage on internal EEPROM)
Interfaces for
Standalone Controller
PLC with
Firmware "High Flow" E1.25 (standard firmware for "High Flow")
Firmware "High Pressure" E2.25 (standard firmware for "High Pressure")
PLC with
Interfaces for
Extended Controller
USB interface (for service and system monitoring)
Firmware "High Flow" E1.48 (standard firmware for "High Flow")
Firmware "High Press." E2.48 (standard firmware for "High Pressure")
Article #
Characteristics
Sensor Power
190-10122 190-10208
190-10123 190-10210 Jacket Material
190-10124 190-10211 Connector Types
190-10101 190-10205 Connector Material
190-10125 190-10212
190-10158 190-10219
190-10159 190-10221 Jacket Material
190-10130 190-10222 Connector Types
190-10160 190-10223 Connector Material
190-10161 190-10224
Characteristics
Material / Connection Port
Air Pressure / Air Consumption
Material
Impeller (a) / O-Ring (b)
Pump Casing Screws (c)
Pump Motor Screws (d)
Imp. Exchange Tool IET-3.1 (e)
Impeller (a)../..O-Ring (b)
Pump Casing Screws (c)
Pump Motor Screws (d)
Imp. Exchange Tool IET-3.1 (e)
Sleeve (a) and Gasket (b)
Frame (c)
2x Cable Module (d)
User Manual for BPS-2000
www.levitronix.com
Note

1
/ Tube 1"
perfluoroelastomer
3
0 0
C / 194 F

1 / Pillar 1" Female
perfluoroelastomer
3
0 0
C / 194 F
II 3G Ex nA IIC T5 Gc
II 3D Ex tc IIIC T100°C Dc
 
10% / 1 x 13.3 – 11.1 A
10% / 2kW @ 50/60Hz
 
10% / 3 x 6.7 – 5.6 A
10%
1x analog input ("Speed")
4 - 20 mA
1x digital input ("Enable")
0 - 24 V (optocoupler)
1x digital output ("Status")
0 - 24 V (relais)
- up to 4 digital inputs 0 - 24V (optocoupler)
- up to 4 digital outputs 0 - 24 V (relais)
- up to 2 analog inputs 4 - 20mA
0 – 10 V
- up to 2 analog inputs
0 – 5 V
- up to 2 analog outputs
Value / Feature
PVC
Circular AMP to D-SUB (a)/COMBICON (b)
Plastics (PA)
PVC
Circular M23 (IP-67) to D-SUB (a)/COMBICON (b)
Metallic – Nickel coated
Value / Feature
PP (+ 40% Talkum) / NPT 1/4"
~1 - 3 bar (14 – 43 psi) / 110 Liter/min = 3.8 SCFM @ 1 bar
PP-EL-S with conductive additive for operation with ATEX motor

LPI-2000.1 in PFA / O-Ring, Kalrez , 98.02 x 3.53
8pcs M8x40, Stainless Steel with PTFE coating
4pcs M8x30, Stainless Steel with PTFE coating
POM-C

LPI-2000.2 in PFA / O-Ring, Kalrez , 98.02 x 3.53
8pcs M8x40, Stainless Steel with PTFE coating
4pcs M8x30, Stainless Steel with PTFE coating
POM-C
Stainless Steel and EPDM Note:
Roxylon (EPDM rubber) Lubricant (e) and measurement
Roxylon (EPDM rubber) plates (f) are included.
/ 2kW @ 50/60Hz
5