YASKAWA SLIO CP 042-1IO00 Manual page 26

Basics and mounting
Wiring power modules
Wiring procedure
Standard wiring
26
1 Pin number at the connector
2 Opening for screwdriver
3 Connection hole for wire
1. Insert a suited screwdriver at an angel into the square opening as shown. Press
and hold the screwdriver in the opposite direction to open the contact spring.
2. Insert the stripped end of wire into the round opening. You can use wires with a
cross section of 0.08mm
3. By removing the screwdriver, the wire is securely fixed via the spring contact to the
terminal.
(1) DC 24V for power section supply I/O area (max. 10A)
(2) DC 24V for electronic power supply bus coupler and I/O area
2 2
up to 1.5mm
HB300 | CP | 042-1IO00 | en | 22-42
System SLIO