Table of Contents
Advertisement
System SLIO
Exchange of a periphery
module
HB300 | CP | 042-1IO00 | en | 22-42
1.
Power-off your system.
2.
Remove if exists the wiring of the module.
3.
For demounting and exchange of a (head) module or a group of
modules, due to mounting reasons you always have to remove the
electronic module right beside. After mounting it may be plugged
again.
Press the unlocking lever at the lower side of the just mounted right module and pull
it forward.
4.
Turn the locking lever of the module to be exchanged upwards.
5.
Pull the module.
6.
For mounting turn the locking lever of the module to be mounted upwards.
7.
To mount the module put it to the gap between the both modules and push it,
guided by the stripes at both sides, to the mounting rail.
8.
Turn the locking lever downward, again.
9.
Plug again the electronic module, which you have removed before.
10.
Wire your module.
ð Now you can bring your system back into operation.
Basics and mounting
Demounting 8x periphery modules
31
Advertisement
Table of Contents
