Maintenance And Cleaning - PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual

(together) defective magnetic sensor, missing magnet), defective stepping motor.
COLOUR WHEEL ERROR 1 (COLOUR WHEEL ERROR 2)
The messages will appear after the reset of the colour wheel if this wheel is not
located in the default position.
CYAN LAMELLA ERROR 1 (CYAN LAMELLA ERROR 2)
The messages will appear after the reset of the CMY module if the cyan lamellas are
not located in the default positions.
MAGENTA LAMELLA ERROR 1 (MAGENTA LAMELLA ERROR 2)
The messages will appear after the reset of the CMY module if the magenta
lamellas are not located in the default positions.
YELLOW LAMELLA ERROR 1 (YELLOW LAMELLA ERROR 2)
The messages will appear after the reset of the CMY module if the yellow lamellas
are not located in the default positions.
CTO LAMELLA ERROR 1 (CTO LAMELLA ERROR 2)
The messages will appear after the reset of the CTO module if the CTO lamellas are
not located in the default positions.
ZOOM ERROR 1 (ZOOM ERROR 2)
The messages will appear after the reset of the zoom module if the module is not
located in the default position.
PAN ERROR 1 (PAN ERROR 2)
The messages will appear after the reset of the yoke if the yoke is not located in the
default position.
TILT ERROR 1 (TILT ERROR 2)
The messages will appear after the reset of the head if the head is not located in the
default position.

MAINTENANCE AND CLEANING

It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-
fluid residues must not build up on or within the fixture. Otherwise, the fixture's
light-output will be significantly reduced. Regular cleaning will not only ensure the
maximum light-output, but will also allow the fixture to function reliably
throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is
recommended, under no circumstances should alcohol or solvents be used!
The front objective lens will require weekly cleaning as smoke-fluid tends to
building up residues, reducing the light-output very quickly. The cooling-fans
should be cleaned monthly.
The interior of the fixture should be cleaned at least annually using a vacuum-
cleaner or an air-jet.
Dichroic colour filters, CMY lamellas and the internal lenses should be cleaned
monthly.
Remove dust and dirt from the fans and cooling vents using a soft brush and
vacuum-cleaner.
44