Lamp On/Off; Test Sequences - PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual

MICROPHONE SENSITIVITY - Select this function to adjust the microphone
sensitivity from 1(maximum) to 20 (minimum). If the sensitivity is correctly
adjusted, the mark will appear (blinking in the bass beat.)
FAN MODES - By using this function you can choose 2 types of the fan speed
operating modes.
AUTO COOLING - The fans automatically raise their speed in order to control
inside temperature of the lighting, if the temperature inside increases about
certain level (the low fan speed reduces the cooling of the lighting). This cycle
can repeat several times until the temperature inside is on a suitable level.
HIGH COOLING - The cooling fans work on max. speed (max. cooling). This mode
we recommend for high ambient temperature (30 °C and more).
PAN/TILT MODE - Use this menu to set the character of the pan/tilt movement.
TIME MODE - - - - Pan and tilt will move with different speeds and they will come at
the same time to end point (pan and tilt sets its optimal speed).
SPEED MODE - - - - Pan and tilt will move with the same speed as adjusted by the
channel 5 (Pan/Tilt speed). E.g. pan will come to the end point and wait for tilt,
which has longer track.
ACTIVE BLACKOUT WHILE: - Use this function if you wish to close the light output
during effect changes.
PAN/TILT MOVING - - - - This function closes the light output during pan/tilt changes.
COLOUR WHEEL MOVING - - - - This function closes the light output during colour
changes.
INIT EFFECT POSITIONS - Select this function to set all effects to the desired
positions. After switching the fixture on (if DMX is not connected), all effects will
move to this init positions.
Note: If you operate 24 channels pre-setting (Mode 3) and you adjust DMX values
for channels which are not included in this mode, you will not be able to change
these effects from the controller !
For example: You operate the Mode 1 and in „Init Effect Positions" menu is adjusted
CMY Colour Macro =150, this value shoud be 0 or you will not able to control cyan,
magenta and yellow because these effects are used in CMY macros and the macros
have a priority. CMY-CTF SPEED - Select this option to select desired speed of
movement of CMY and CTF lamelas: Standard speed or High speed. Default setting
is Standard speed.
DEFAULT SETTINGS - Select this option to reset all fixture personalities to the
default values.

LAMP ON/OFF

Use this option in order to switch on/off the lamp. It is also important to note, that
the lamp is cold restrike type, that means, that it has to be cold before striking.

TEST SEQUENCES

Use this menu to run a special demo-test sequences without an external controller,
which will show you some possibilities of using DreamLight 1200CNE.
39