Lamp Adjustment; Inserting/Exchanging Colours - PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual

manufacturer's notes paying attention to do not touch the glass bulb bare hand
during the installation!
6. Reinsert the lamp cover with the lamp holder and installed lamp back to
the head and tighten the 2 quarter-turn fasteners again.
7. Align the new lamp.
8. Reset „Lamp On Time " and „Lamp Strikes " counters in „Fixture information
" menu.

LAMP ADJUSTMENT

The lamp holder is aligned at the factory.
Due to differences between lamps, fine adjustment may improve light
performance:
1. Switch on the fixture and after reset turn on the lamp.
2. Cancel all effects, open the shutter and focus the light on a flat surface
(wall)using either DMX controller or function "Lamp adjustment " in "Special
functions menu ".
3. Center the hot-spot (the
brightest part of the beam)using
the three adjustment
„A,B,C ". Turn one screw at a time
to drag the hot-spot, diagonally
across the projected image. If you
cannot detect a hot -spot, adjust
the lamp until the light is even. To
reduce a hot-spot, pull the lamp in
by turning all three screws „A,B,C
"clockwise 1/4-turn at a time until
the light is evenly distributed. If
the light is brighter around the
edge than it is in the center, or if
light output is low, the lamp is too
far back in the reflector. „Push" the
lamp out by turning the screws
„A,B,C "counter-clockwise 1/4-turn
at a time until the light is bright
and evenly distributed.

INSERTING/EXCHANGING COLOURS

DANGER! Install the colours with the device switched off only.
Unplug from mains before!
Turn off the lamp and allow it to cool for at least 10 minutes. Disconnect the fixture
from power.
Open the bottom cover of the moving head by loosening the 4 quarter-turn
fasteners on the top cover and follow the instructions below:
screws
30
3 adjustment screws "A, B, C" 3 adjustment screws "A, B, C"
3 adjustment 3 adjustment screws "A, B, C" screws "A, B, C"