PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual page 26

Please note that as part of Proel SpA's ongoing commitment to continuous product
development, specification are subject to change without notice. Whilst every care
is taken in the preparation of this manual Proel SpA reserves the right to change
specifications in the course of the product improvement. The publishers cannot be
held responsible for the accuracy of the information herein, or any consequence
arising from them.
ATTENTION ! ATTENTION ! This instruction manual contains important information about the
ATTENTION ! ATTENTION !
installation and use of the projector. Please read and follow these instruction
carefully.
Every person involved with installation and maintenance of this device have to:
- be qualified
follow the instructions of this manual
CAUTION! Be careful with your operations.
With a high voltage you can suffer a dangerous electric shock when touching the
wires!
Important:
The manufacturer will not accept liability for any resulting damages caused by the
non-observance of this manual or any unauthorized modification to the device.
Please consider that damages caused by manual modifications to the device are
not subject to warranty.
Never let the power-cord come into contact with other cables!
Handle the power-cord and all connections with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Always plug in the power plug least.
Make sure that the power-switch is set to off-position before you connect the
device to the mains.
The power-plug has to be accessable after installing the device.
Make sure that the power-cord is never crimped or damaged by sharp edges.
Check the device and the power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning
it.
Only handle the power-cord by the plug. Never pull out the plug by tugging the
power-cord.
25