PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual page 44

ACTIVE LAMP TIMER
This message appears if you try to switch on the lamp within 5 minutes after having
switched it off (the lamp is too hot). The message will appear on the display if the
lamp doesn't ignite within 28 seconds. The DreamLight 1200CNE will store this
information and automatically ignite the lamp when the 5 minutes period has
expired.
Caution: The message is disabled if the lamp light sensor (function „Lamp Sensor" Caution:
Caution: Caution:
in menu Personality) is switched Off.
Lamp Error
The ignition of the lamp is seven times unsuccessful (the "
message appeared six times before), and the display shows " " " "
that the lamp could be damaged or even missed or there could be a failure on the
ignitor or ballast.
Please place or replace the lamp and contact your dealer if the situation was not
caused by the lamp.
Caution: The message is disabled if the lamp light sensor (function „Lamp Sensor" Caution: Caution: Caution:
in menu Personality) is switched off.
OVERHEATED ->LAMP LOW
This message informs that the fixture head is overheated and the lamp power was
reduced to 700 W. After 10 minutes the lamp power will be switched to the full
power.
OVERHEATED ->LAMP OFF
This message informs that the fixture head is overheated and the lamp was
switched off by its temperature sensor.
Lamp Sensor Error
This message informs the lamp light sensor is failed.
Caution: The message is disabled if the lamp sensor (function Lamp Sensor in menu Caution:
Caution: Caution:
Personality) is switched Off.
SHORT POWER ERROR
This message will appear if the fixture was shortly disconnect from the main.
SUPPLY FREQUENCY ERROR
This message will appear if the frequency of the main is not standard 50 or 60 Hz.
This message can appear as a result of the interference during the lamp starting (if
the lamp or igniter is old) or as a result of the interference by neighbouring devices.
In these cases the message does not affect the fixture operating! In these cases the message does not a In these cases the message does not a In these cases the message does not a
The following error messages are separated into 2 groups:
xxxx xxxx error 1 (e.g. Colour Wheel 1 Error 1, Colour Wheel 2 Error 1)
xxxx xxxx error 2 (e.g. Colour Wheel 1 Error 2, Colour Wheel 2 Error 2)
There are some possible reasons of faults:
Message Characteristic fault
xxxx xxxx Error 1 Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the PCB)
xxxx xxxx Error 1/xxxx xxxx Error 2 Magnetic sensor is permanently Off (e.g. leading
wire is disconnected,
ffect the fixture operating! ffect the fixture operating! ffect the fixture operating!
43
Active Lamp Timer
Lamp Error
" " " " , meaning
"