Safe Usage Of The Projector - PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual

This device falls under protection class I. Therefore it is essential to connect the
yellow/green conductor to earth.
The electric connection, repairs and servicing must be carried out by a qualified
employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short intervals as this would reduce the
lamp's life.
During the initial start-up some smoke or smell may arise. This is a normal process
and does not necessarily mean that the device is defective.
Do not touch the device's housing bare hands during its operation (housing
becomes hot)!
For replacement use lamps and fuses of same type and rating only.

SAFE USAGE OF THE PROJECTOR

This device is a moving-head spot for creating decorative effects and was designed
for indoor use only.
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation water
might damage your device. Leave the device switched off until it has reached
room.
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the projector-head, as the mechanics may be
damaged. Always hold the fixture at the transport handles.
When choosing the installation location, please make sure that the device is not
exposed to extreme heat, moisture or dust.
There should not be any cables lying around. You endanger your own and the
safety of others!
The minimum distance between light-output and the illuminated surface must be
more than 3 meters.
Always fix the fixture with an appropriate safety rope. Fix the safety rope at the
correct holes only.
Only operate the fixture after having checked that the housing is firmly closed and
all screws are tightly fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open
,as discharge lamps may explode and emit a high ultraviolet radiation, which may
cause burns.
The maximum ambient temperature 40 °C must never be exceeded. Otherwise, the
lamp is switched off and the fixture is out of operation for 5 minutes
.
The lens has to be replaced when it is obviously damaged, so that its function is
impaired, e.g. due to cracks or deep scratches!
26