PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual page 39

LAMP PRESETTING - Select this menu to change the lamp „behaviour".
LAMP ON/POWER ON - Select this function to turn the lamp on automatically
after switching the fixture on.
LAMP OFF VIA DMX - Select this function to switch off the lamp via DMX.
LAMP ON IF DMX PRESENT - This function allows you to strike the lamp
automatically after 26 seconds if DMX signal is present on the data link. If the
ignition is unsuccessfull (e.g. the lamp is too hot), the fixture will try to ignite the
lamp after next 26 s. This process will repeat until the lamp lights.
LAMP OFF IF NOT DMX - This function allows you to switch Off the lamp
automatically after 2 minutes if DMX signal is missing on the data link.
LAMP IGNITION DELAY - This function allows you to set the time delay( 0-90s)
before the lamp will be ignited. This setting will not affect starting the lamp
direct from the control panel (menu "Lamp On/Off").
LAMP LOW POWER DELAY - This function enables set the time period after that
the lamp power will be reduced if the shutter/dimmer is closed.The delay time
can be set up to 600seconds.Default setting is10s.
LAMP LIGHT SENSOR - Select this function to switch the lamp light sensor on or off.
The option „On" is for the standard operation.
Important: The option „Off" is for „emergency operation" only if the lamp light
sensor is defective and you will wait for a service intervertion! If the lamp light
sensor is switched off and at switching the lamp on the electronics will still try to
ignite the lamp until it shines (even when the lamp is damaged or absent), on this
account some electronics parts could be damaged!
DISPLAY ADJUSTING - This function allows you to change the display settings.
DISPLAY PERMANENT ON - This function allows you to keep the display on or to
turn off automatically 2 minutes after last pressing any button(or a wheel
movement) on the control panel.
DISPLAY INTENSITY - Select this function to adjust the display intensity (1-
min.,10-max.).
DISPLAY BACKLIGHT - Select this function to adjust the display backlight (1-
min.,10-max.).
DISPLAY TURNED - Select this function to turn the display by 180°.
BLACKOUT D.M.C. - Select this function to enable the blackout during the head
movement correction (if the moving head lost its right pan/tilt position for a short
moment).
PAN/TILT FEEDBACK - This function allows to return the mowing head to the
required pan/tilt position after changing the position by external force (e.g.by
stroke).
Be careful, the Pan/Tilt Feedback OFF is not the standard operation and the head of
the fixture can be demaged!
Note: : : : If the feedback was switched off, the pan/tilt-position is changed by an
external force and the feedback is switched on again, the moving head might not
to be synchronized with the DMX signal. You have to make a reset in order to
synchronize the moving head with the DMX signal.
38