Fixation Via The Omega Holders - PROEL DREAMLIGHT 1200 ECLIPSE WASH User Manual

If the fixture shall be lowered from the ceiling or high joists, professional trussing
systems have to be used. The fixture must never be fixed swinging freely in the
room.
Caution: Fixtures may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do not install the fixture!
Before rigging make sure that the installation area can hold a minimum point load
of 10 times the fixture 's weight.
Danger of fire!
When installing the device, make sure there is no highly inflammable material
(decoration articles, etc.) in between a distance of min.1,2 m.
CAUTION! Use 2 appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly!
Ensure that the structure (truss) to which you are attaching the fixtures is secure.
The moving-head can be placed directly on the stage floor or rigged in any
orientation on a truss without altering its operation characteristics .
The Omega holders can be placed in 4 positions on the bottom of the base. Use the
clamps with screws M12.
Pull the safety rope through the two apertures on the bottom of the base and over
the trussing system etc.

FIXATION VIA THE OMEGA HOLDERS

Bolt each clamp (1) to the omega holder (4) with M12 bolt and lock nut through the
hole in the holder.
2. Fasten the omega holders on the bottom of the base by inserting both
quick-lock fasteners (3) into the holes of the base and tighten fully clockwise.
3. Fasten the safety-rope (2) through the two apertures on the bottom of the
base and over the trussing system.
32