Remove Firewood From The Exit Chute - Wallenstein WP525 Operator's Manual

WP525
Firewood Processor
7.3 Remove Firewood from the Exit
Chute
WARNING!
Before using the step, stop the machine, and
then clean the step and the area below it.
Unexpected machine movement, and cluttered or
slippery conditions create slip and fall hazards.
A slip or fall can result in serious injury or death.
Remove all debris, mud, wet grass, wet leaves,
ice, or other material that is on or below the step.
WARNING!
Always hold the exit-chute handle while using
the step. Incorrect or careless use of the step can
result in a slip or fall that causes serious injury
or death. Move slowly and always hold the exit-
chute handle when using the step.
For more information, see Step on page 24.
1. Stop the machine.
For instructions, see Stop the Machine on page 34.
2. Remove all debris, mud, wet grass, wet leaves, ice, or other
material from the step and the area below it.
3. Hold the exit-chute handle.
Figure 46 – Transport position
4. Step up onto the step.
Continue to hold the exit-chute handle while on the step.
5. Push the firewood up and out of the exit chute by hand.
6. Carefully, step down off the step, and then release the exit-
chute handle.
51
Transport
01775