Exit Chute - Wallenstein WP525 Operator's Manual

Operating Instructions

6.14 Exit Chute

The splitter pushes the firewood up the exit chute and out of the
machine.
6.14.1 Unfold the Exit Chute
1. Remove the snap-lock pin from the bracket on the end of
the splitter.
2. Remove the linchpin from the tab on the RH side of the exit
chute and wedge guard.
3. Use the exit-chute handle to carefully unfold the exit chute.
Make sure that the square tube on the bottom of the exit
chute goes between the brackets on the end of the splitter.
4. Insert the snap-lock pin through the splitter bracket and exit
chute.
5. Insert the linchpin (removed in step 1) through the tab on
the wedge guard for safekeeping.
Figure 27 – Unfold the exit chute
6.14.2 Fold Up the Exit Chute
1. Remove the linchpin from the tab on the RH side of the
wedge guard.
2. Remove the snap-lock pin that secures the exit chute to the
splitter.
3. Use the exit-chute handle to carefully fold up the exit chute.
4. Insert the linchpin (removed in step 1) through the tab on
the exit chute and the wedge guard to secure the exit chute
in position.
5. Insert the snap-lock pin through the bracket on the exit
chute for safekeeping.
Figure 28 – Fold up the exit chute
01784
38
WP525
Firewood Processor
01786