Keep this manual with the machine at all times and available for frequent reference. W034 Congratulations on your choice of a Wallenstein WXT15H or WXT20H Log Splitter! This high-quality machine is designed and manufactured to meet the needs of homeowners or small businesses.
Log Splitter 1.1 Delivery Inspection Report Wallenstein WXT15H / WXT20H Log Splitter To register your product and start the warranty, go to WallensteinEquipment.com. This form must be completed by the dealer at the time of delivery, and then signed by the dealer and customer.
WXT15H / WXT20H Introduction Log Splitter 1.2 Serial Number Location Always provide the model and serial number of your Wallenstein product when you order parts, or request service or other information. The product information plate location is shown in the following illustration.
This type of label gives the operator information or shows the operation of a There are different types of labels on your Wallenstein product. control. The labels are for safety, information, and product identification.
YOU are responsible for the safe operation and maintenance of DANGER your Wallenstein product. YOU must make sure that you and Identifies a hazardous situation that, if not avoided, will result in anyone else who uses, maintains, or works around the machine serious injury or death.
Power equipment with or without a vehicle attached can often be noisy enough to Wallenstein Equipment puts considerable effort into designing cause permanent, partial hearing loss. products that are safe to use; however, it is also the responsibility of the operator to use the equipment safely.
WXT15H / WXT20H Safety Log Splitter 2.5 Equipment Safety Guidelines 2.6 Safe Condition Safety is one of the primary concerns in the design and References are made to safe condition throughout this manual. development of equipment. However, every year many accidents...
WXT15H / WXT20H Safety Log Splitter 2.8 Training Record The design and manufacture of this product conforms to the applicable provisions in the following standards: Everyone who uses this machine must read and fully understand • ISO 4254-1 Agricultural machinery – Safety all safety and operation information in this manual.
WXT15H / WXT20H Safety Log Splitter 2.9 Work Site 2.9.2 Create a Safe Work Area Read and obey the instructions for safe operation of the CAUTION! machine. Keep bystanders and workers safe from hazards. Obey the The operator must be fully familiar with the work following important guidelines: site before starting work.
Page 12
WXT15H / WXT20H Safety Log Splitter 1. Safe zone 2. Work zone 10 ft (3 m) 10 ft (3 m) 10 ft (3 m) 10 ft (3 m) 02604 Figure 2 – Example of a safe work area...
Replacement safety labels are available damaged, or illegible. If a component is replaced from your local Wallenstein Equipment dealer or distributor. and it has a safety label on it, apply a safety label to the new component. Operating the machine •...
Safety Labels Log Splitter 3.2 Safety Label Locations The WXT20H is shown, but the WXT15H safety labels are the same. Numbers correspond with the Safety Label Definitions on page 16. 02605 Figure 3 – Safety label locations- left side (WXT20H shown)
Page 15
WXT15H / WXT20H Safety Labels Log Splitter 02606 Figure 4 – Safety label locations- right side (WXT20H shown)
WXT15H / WXT20H Safety Labels Log Splitter 3.3 Safety Label Definitions 4. Caution! Read the Operator's Manual 1. Warning! There is important safety information Crush, pinch, cut, or sever hazard and instructions in the Operator's Manual. Hands or fingers can be crushed, pinched, cut, or severed in this area.
WXT15H / WXT20H Controls Log Splitter 5. Controls 5.2 WXT15H Engine Controls WARNING! Do not operate the machine until you know the IMPORTANT! For complete information about the engine location of all the controls and how to use them controls, see the engine manufacturer's manual.
WXT15H / WXT20H Controls Log Splitter 5.2.2 Choke Control 5.2.3 Starter-cord Handle The choke control lever has the following functions: WARNING! Closed Fast retraction of the starter cord (called Close the choke to start a cold engine. kickback) pulls your hand and arm toward the engine faster than you can let go of the handle.
WXT15H / WXT20H Controls Log Splitter 5.3 WXT20H Engine Controls 5.3.2 Choke Control The choke control lever has the following functions: IMPORTANT! For complete information about the engine Closed controls, see the engine manufacturer's manual. Close the choke to start a cold engine.
Page 22
WXT15H / WXT20H Controls Log Splitter 5.3.3 Starter-cord Handle WARNING! Fast retraction of the starter cord (called kickback) pulls your hand and arm toward the engine faster than you can let go of the handle. Serious bodily harm (for example; bruises, sprains, fractures, and broken bones) can result.
WXT15H / WXT20H Operating Instructions Log Splitter 6. Operating Instructions The operator is responsible to be familiar with and obey the • Only operate the engine in a location that has good air operating and safety procedures. flow. Engine exhaust gases contain carbon monoxide (an odorless gas) that can cause asphyxiation.
WXT15H / WXT20H Operating Instructions Log Splitter 6.2 Pre-Start Checklist 6.3 Machine Break-In Do the following before you start the machine the first time and Before and during the first eight hours of operation, do the each time after that.
To purchase a spark arrestor, contact your local Wallenstein dealer or distributor. W019 • Keep the cylinder fins and engine shrouds free of debris to For complete safety and operating information, see the engine prevent the engine from overheating.
Page 26
If the engine floods, do one of the following: Check the engine fuel level before each use. • WXT15H: set the choke control to Open, and then try to start the engine again. Start work with a full fuel tank to decrease operating interruptions.
Page 27
The engine must be in a level position for the WXT15H fuel tank capacity: 0.27 US gal (1 L) dipstick to show the oil level correctly. WXT20H fuel tank capacity: 1.59 US gal (6 L).
Page 28
WXT15H / WXT20H Operating Instructions Log Splitter 02628 Figure 18 – WXT15H- engine oil-fill location 01823 Figure 17 – WXT20H- check the engine oil level 6.4.6 Add Oil to the Engine IMPORTANT! For more information about engine oil, see the engine manufacturer's manual and Engine Oil on page 1.
WXT15H / WXT20H Operating Instructions Log Splitter 6.5 Hydraulic System Operation 6.5.2 Check the Hydraulic Fluid Level IMPORTANT! Do not operate the machine if the hydraulic IMPORTANT! Check the hydraulic fluid quality every fluid level is low. Damage to the motor and other 50 hours.
VanguardPower.com. 10. Clean the area around the fill cap and remove any spilled fluid. 6.6.1 Start a WXT15H 1. Do the tasks described in the Pre-Start Checklist on page 2. Set up the machine. For instructions, see Set Up the Machine on page 32.
The procedures in this section only apply to an emergency situation. 2. Set up the machine. 6.8.1 Stop a WXT15H in an Emergency For instructions, see Set Up the Machine on page 32. 3. Make sure that the splitter control is in the Neutral position.
WXT15H / WXT20H Operating Instructions Log Splitter 6.9 Set Up the Machine 6.10 Operate the Log Splitter 1. Select a work site and set up a safe work area. WARNING! For more information, see Work Site on page 11. 2. Do one of the following: Wear the personal protective equipment (PPE) that is necessary to do the work safely.
Page 33
WXT15H / WXT20H Operating Instructions Log Splitter 6.10.2 Split a Log 8. Do steps 4 to 7 again, until the work is complete. WARNING! Do not let more than one person handle the log or split wood and operate the machine. A second person can be pinched, crushed, or have their hand or fingers severed by the wedge.
Transport safety and transport of machinery. 1. Stop the machine. WXT15H models are not intended for use or transport on public roadways. Therefore, the machine does not include For instructions, see Stop the Machine on page 31. the necessary lights, reflectors, and markings.
WXT15H / WXT20H Transport Log Splitter 7.3 Ball-mount Hitch 3. Remove the pin from the hitch-coupler latch. Lift the latch to the vertical (unlocked) position. The machine comes with a ball-mount hitch coupler. 4. Slowly, reverse the tow vehicle until the ball-mount hitch is below the hitch coupler.
WXT15H / WXT20H Transport Log Splitter 7.4 Clevis Hitch 7.4.2 Disconnect from a Clevis Hitch Always park the machine on level, dry ground that is free of The machine comes with a clevis hitch. Remove the ball-mount debris and other objects before disconnecting the hitch.
WXT15H / WXT20H Transport Log Splitter 7.5 Jack Stand 7.5.2 Lift the Jack Stand 1. Support the machine to remove weight from the jack stand. Attach the machine to a tow vehicle or support the front of CAUTION! the machine with blocks.
WXT15H / WXT20H Storage Log Splitter 8. Storage At the end of the season or when the machine is not going to be 9. Block the machine wheels to prevent accidental movement used for an extended length of time, store the machine correctly and increase the wheel bearing life.
WXT15H / WXT20H Service and Maintenance Log Splitter 9. Service and Maintenance Regular preventive maintenance can improve performance and Put the machine in a safe condition before you start any prolong the life of the machine. Machine maintenance is your service or maintenance: responsibility.
WXT15H / WXT20H Service and Maintenance Log Splitter 9.2.3 Engine Fuel • When replacement parts are necessary, use genuine factory replacement parts to restore your machine to For complete fuel information and use at high altitudes, see the original specifications. The manufacturer cannot be the engine manufacturer's manual.
N/A indicates that a reference is not applicable. In dusty conditions or when airborne debris is present, clean more often. This task only applies to the WXT15H engine. This task only applies to the WXT20H engine. Every third air filter change, replace the air safety filter.
9.4.2 Grease Fitting Locations The illustration below shows the WXT20H, but the grease points IMPORTANT! Do not over grease a bearing. Too much for the WXT15H are the same. grease can cause the bearing seals to fail. 9.4.1 Hinge and Pivot Point Locations Look for this type of label on the machine.
Replace fuel lines or fittings that are damaged. 02627 • Store fuel away from all wood material. Figure 32 – WXT15H- engine air filter • Do not check for a spark with the spark plug or spark plug wire removed.
WXT15H / WXT20H Service and Maintenance Log Splitter 9.6 Hydraulic System Maintenance • Put on the correct eye protection when doing an inspection for a high-pressure hydraulic leak. The hydraulic system provides pressurized hydraulic fluid to the splitter control and hydraulic cylinder. The hydraulic system makes the wedge extend or retract.
Page 45
WXT15H / WXT20H Service and Maintenance Log Splitter 9.6.2 Change the Hydraulic Fluid and Filter 13. Dispose of the used hydraulic fluid in an environmentally safe manner. CAUTION! Risk of burns to exposed skin. Hydraulic fluid gets hot during operation, which makes hoses, lines, and other parts hot as well.
WXT15H / WXT20H Service and Maintenance Log Splitter 9.7 Clean the Machine 9.8 Tire Maintenance IMPORTANT! Do not use gasoline, diesel fuel, or thinners WARNING! for cleaning. Harsh chemicals can damage the machine finish. Failure to follow the correct procedures when...
Set the machine to a safe condition. or Wallenstein Equipment. When you contact someone, please have the serial number of your product available. To find the For engine troubleshooting, see the engine manufacturer's serial number on your machine, see Serial Number Location on manual.
WXT15H / WXT20H Specifications Log Splitter 11. Specifications For engine specifications, see the engine manufacturer's documentation. For available accessories, go to WallensteinEquipment.com. 11.1 Machine Specifications Parameter WXT15H WXT20H Compatibility Towable or self-contained Engine Briggs & Stratton® 5.5 hp (190 cc) Vanguard®...
WXT15H / WXT20H Specifications Log Splitter 11.3 Bolt Torque IMPORTANT! If you replace hardware, use fasteners of Imperial Bolt Torque Specifications the same grade. Torque Bolt SAE Gr. 2 SAE Gr. 5 SAE Gr. 8 Diameter IMPORTANT! The torque specifications in these tables lbf•ft...
Page 52
WXT15H / WXT20H Index Log Splitter Total weight ������������������������������������������������������������������������� 48 Training Prepare the material������������������������������������������������������������ 32 New operator ����������������������������������������������������������������� 17 Pre-start checklist���������������������������������������������������������������� 24 Safety training ������������������������������������������������������������������ 9 Product identification plate location��������������������������������������� 5 Training record ��������������������������������������������������������������� 10 Transport ����������������������������������������������������������������������������� 34 Ball-mount hitch ������������������������������������������������������������� 35 Register your product ������������������������������������������������������������...