Table of Contents
Advertisement
WP525
Firewood Processor
6.15 Adjust a Support Stand
Two support stands provide stability during machine operation.
Each support stand has a base that can be set to the raised or
lowered position.
1. Hold the base to prevent it from falling.
2. Remove the snap-lock pin.
3. Raise or lower the base to the required position on the
support leg.
4. Insert the snap-lock pin through the base and support leg
to secure the base in position.
1
4
Figure 29 – Adjust a support stand
1. Raised position
2. Support tube
3. Snap-lock pin
2
3
02024
4. Base (in the lowered
position)
6.16 Set the Log-length Guide
Set the log-length guide to the desired log length for consistent
saw cuts. The log-length guide can be set to cut logs to
any length between 12 and 22 inches (30 and 56 cm). The
measurements are shown on top of the guide rail.
1. Turn the handle counterclockwise to loosen it.
2. Slide the handle sideways and align the log-length guide
with the desired setting.
3. Turn the handle clockwise to tighten it.
Figure 30 – Set the log-length guide
1. Log-length guide
2. Handle
3. Guide rail
39
Operating Instructions
3
1
2
01760
Advertisement
Table of Contents
