Start The Machine - Wallenstein WP525 Operator's Manual

WP525
Firewood Processor
7. Close the draw latch over the catch on the adapter. This
secures the chain saw to the holder.
Figure 22 – Holder draw latch
8. Rotate the holder and move the chain saw through the full
range of motion. Make adjustments to the pivot base, as
required (based on the saw length).
9. Check the chain saw range of motion. Make sure that the
chain-saw bar cannot contact any part of the machine. If
required, remove the chain saw from the holder and adjust
the adapter position.
6.6.3 Start the Chain Saw
1. Open the holder draw latch.
2. Slide the chain saw out of the holder.
3. Start the chain saw.
For instructions, see the chain saw manufacturer's manual.
4. Carefully, slide the adapter into the holder guides.
For more information, see Figure 21 on page 32.
5. Close the draw latch over the adapter catch to secure the
chain saw to the holder. See Figure 22.

6.7 Start the Machine

Fast retraction of the starter cord (called
kickback) pulls your hand and arm toward the
engine faster than you can let go of the handle.
Serious bodily harm (for example; bruises,
sprains, fractures, and broken bones) can result.
When starting the engine, pull the starter cord
slowly until you feel resistance, and then pull it
rapidly to avoid kickback.
Before you start the machine, read and
understand all of the safety information in this
02025
manual, the engine manufacturer's manual, and
the chain saw manufacture's manual.
IMPORTANT! If the engine does not start after
repeated attempts, contact your local dealer or go to
VanguardPower.com.
Before you start the machine, see the information under
Controls on page 22.
1. Complete the tasks described in the Pre-Start Checklist on
page 26.
2. Make sure that the machine is set up correctly, level, and in
a stable position.
3. Move the hydraulic controls to the neutral position (out of
detent).
4. Move the choke control to the Closed position.
5. Move the throttle control to the Fast position.
6. Firmly grip the starter-cord handle.
7. Pull the starter cord out slowly until you feel resistance, and
then pull it rapidly.
8. When the engine warms up, move the choke control to the
Open position.
9. Start the chain saw, and then slide it into the holder.
For more information, see Chain Saw Safety on page 31
and Start the Chain Saw.
33
Operating Instructions
WARNING!
WARNING!
W102