Table of Contents
Advertisement
WP525
Firewood Processor
6. Operating Instructions
Read and understand all of the operating instructions before
using the machine.
6.1 Operating Safety
WARNING!
Wear the personal protective equipment (PPE)
that is required to complete the work safely.
This includes, but is not limited to a hard hat,
hearing protection, a face shield, protective
footwear, a respirator, and heavy gloves.
WARNING!
Always use the machine outdoors and park
the machine in a position where the prevailing
winds blow the engine exhaust away from the
operator. Exhaust from the engine contains
carbon monoxide (CO) that can accumulate to a
dangerous level, even in an area with good air
fl ow.
The operator is responsible to be familiar with and follow all
operating and safety procedures. Read and understand all the
safety information in this manual before operating the firewood
processor.
• Read the chain saw and engine manufacturer's manuals
and follow all safety instructions.
• Park the machine in a clear location on dry, level ground.
Do not operate the machine on a hillside or in an area that
is cluttered, wet, muddy, or icy to prevent slips and trips.
• Keep the work area clean and free of debris.
• Never operate an engine inside a closed building. The
exhaust fumes may cause asphyxiation.
• Before starting the machine, close and secure all guards,
shields, deflectors, and covers. If a guard, shield, or cover
is removed, replace it.
• De-limb logs before loading them.
• Do not try to process more than one log at a time. The extra
log can move unexpectedly and cause injury.
• Never reach into the splitting area with your hands while the
machine is operating. Use a tool to reposition cut logs in
the splitting area (for example, a hookaroon or peavey).
• Do not try to split logs across the grain. Logs can burst or
splinter, and then fly out of the machine causing injury.
• Use care when pulling logs from a pile. The logs can roll
when you attach a rope or while being pulled. Use a tool
to position or handle logs (for example, a hookaroon or
peavey).
• Do not move or transport the machine with the engine on.
• Never stand, sit, or climb on any part of the machine while
the engine is on.
• Never operate the machine alone! Always have at least
two fully trained people present:
- It is recommended that there be one operator and one
spotter present during machine operation. Both the
operator and spotter must be completely familiar with all
the machine safety, controls, and operating functions.
W101
- The operator must be in control of the machine at all
times. The spotter must remain outside of the hazard
zone while the machine is in operation.
• Keep bystanders at least 20 ft (6 m) from the stacking
zone. Mark the safe zone with safety cones.
• Turn off the engine before leaving the machine unattended.
• Before operation, complete the tasks described in the Pre-
Start Checklist on page 26.
W006
25
Operating Instructions
Advertisement
Table of Contents
