5.4.2
Mounting the CM on a non-conductive base
Requirement
Non-conductive base for mounting the module.
Required tools
You need the following tools to connect to the functional ground:
• Screwdriver
• Stripping tool
• Crimp tool
Accessories required
To connect to functional ground with a non-conductive mounting base, you can need the
following accessories:
• Fastening screw (M4) and washer
• Cable lug suitable for M4 screws
• Ground conductor cable (copper braid) with a minimum cross-section of 4 mm
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 03/2022, C79000-G8976-C512-04
5.4 Connecting CM to functional ground
Connection
2
39