Siemens SIMATIC RF185C Operating Instructions Manual page 83

IO-Link process data assignment
You can select the connected IO-Link device in the "IO-Link process data assignment" area via
the "IO-Link device" drop-down list. If an IO-Link device from Siemens has been selected, the
Mapping lines are automatically populated accordingly and the bit assignment is displayed.
Otherwise, you need to perform the mapping manually. In the input/output mapping lines,
you specify the 8 bits of the IO-Link device that should be accessed (by entering the number
"1").
Digital inputs/outputs
In the "Digital inputs/outputs" area, you can make the following settings for each output:
Table 7- 9
Boxes
Inactivity
Reset time
Select the check box "Ignore PLC" to ensure that changes of the output bit via the controller
do not have an effect on the physical outputs of the communication module. Changes at the
digital outputs of the communication module are still being transferred to the controller.
In the "Events" area, you can define events/conditions that cause a digital output to change to
one of the following statuses:
• On
The output is turned on.
• Off
The output is turned off.
• Inverted
The output changes its status starting from the status that is active at the moment the
event occurs.
Click the button
events.
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 03/2022, C79000-G8976-C512-04
Description of the status properties
Description
Status that the output adopts following device startup.
If the reset time is set to a value ≠ 0, the output automatically returns to the
inactivity status when the reset time has elapsed. A value of 0 means that the
status of the output is not influenced by this automatic function.
Value range
Increment
to add new events. Click the button
Configuring with the WBM
7.3 The menu items of the WBM
0 ... 65535 ms
1 ms
to remove already specified
83