Siemens SIMATIC RF185C Operating Instructions Manual page 138

Service and maintenance
9.2 Error messages
AutoId OPC UA
status status
7 good
8 good
9 good
9 good
10 good
14 good
14 good
15 good
17 good
18 good
19 good
19 good
19 good
19 good
19 good
19 good
19 good
19 good
20 good
138
AutoId
text
OUT_OF_
RANGE_ERROR
NO_
IDENTIFIER
MULTIPLE_
IDENTIFIERS
MULTIPLE_
IDENTIFIERS
READ_
ERROR
WRITE_
ERROR
WRITE_
ERROR
NOT_SUPPORTED_
BY_DEVICE
DEVICE_NOT_
READY
INVALID_
CONFIGURATION
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
DEVICE_FAULT
Error description
The requested data is not available.
There is no transponder with the required EPC ID/UID in the
transmission window or there is no transponder at all in the
antenna field.
More transponders are located in the transmission window than
can be processed at the same time by the reader.
There is more than one transponder in the transmission
window.
Read access to the transponder has failed.
Write access to the transponder has failed.
Writing the EPC ID/UID on the transponder has failed.
Unknown command
An uninterpretable XML command was sent to the reader or the
Ident profile sends an uninterpretable command to the reader.
Possible causes:
• The "AdvancedCmd" block was supplied with an incorrect
"CMD".
• The "CMD" input of the "AdvancedCmd" block was
overwritten.
The specified read point is not active because no antenna was
assigned to it.
The specified tag field of the transponder is unknown.
The transponder is not responding.
The verification of the written transponder data has failed.
General transponder error
The transponder has too little power to execute the command.
The transponder signals a CRC error.
The selected frequency is not enabled.
The carrier signal is not activated.
General radio protocol error
Fault in power supply
The power supply is very close to the low limit.
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 03/2022, C79000-G8976-C512-04