Siemens SIMATIC RF185C Operating Instructions Manual page 19

Procedure as Rockwell user
1. Connect the hardware
You can find information on this in the section "Connection (Page 29)".
2. Assign the IP address / device name
You can find information on this in the section "Assigning the IP address / device name
with SINEC PNI (Page 52)" or "Assigning an IP address via DHCP (Page 53)".
3. Configure the communication module
You can find information on this in the sections "Configuring with Studio 5000 Logix
Designer (Page 62)" and "Configuring with the WBM (Page 63)".
4. Configure / program the reader commands
You can find information on this in the section "Programming via Rockwell controller
(Page 116)".
Orientation in the document
Later in the document, these symbols will help your orientation and will show you whether
the section is of interest to you or not. Only the sections with user-specific content, in other
words, content that is interface-specific, contain these symbols. Sections without these
symbols are general and relevant for all areas of application.
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 03/2022, C79000-G8976-C512-04
Description
3.3 User-specific procedure
19