Mounting The Cm On A Non-Conductive Base - Siemens SIMATIC RF166C Operating Instructions Manual

Connecting
5.4 Connecting CM to functional ground
5.4.3

Mounting the CM on a non-conductive base

Requirement
Non-conductive base for mounting the module.
Required tools
You need the following tools to connect to the functional ground:
• Screwdriver
• Stripping tool
• Crimp tool
Accessories required
To connect to functional ground with a non-conductive mounting base, you can need the
following accessories:
• Fastening screw (M4) and washer
• Cable lug suitable for M4 screws
• Ground conductor cable (copper braid) with a minimum cross-section of 4 mm
36
Operating Instructions, 03/2022, C79000-G8976-C578-02
2
SIMATIC RF166C