Outputs And Accessories - DITEC ENTREMATIC E1HBOX Manual

6.

OUTPUTS AND ACCESSORIES

Output Value - Accessories
0 1
-
+
1 13
0 14
230 V~ 25 W
C NO
230 V~ 100 W
L N
AUX
COM
-M +M
BAT
2x12 V 1.2 Ah
IP1982EN 2012-03-22
Accessories power supply. Power supply output for external ac-
cessories, including automation status lamp.
24 V 0.3 A
Automation status lamp (proportional).
The light switches off when the automation is closed; the light
24 V 3 W
switches on when the automation is open; the light ashes with a
variable frequency while the automation is operating.
Flashing light. Activated during opening and closing operations.
LAMPH
NOTE: two AM
24 V 25 W
connected.
Internal courtesy light. A courtesy light that turns on for 180 s with
LUXKBOX
every opening (total or partial), step-by-step and closing command
can be connected in series to the NO contact.
External courtesy light. An external courtesy light that turns on for
180 s with every opening (total or partial), step-by-step and closing
command can be connected.
The control panel has one housing for plug-in cards such as a radio
receiver type, magnetic loops, etc.
Plug-in card operating is selected using DIP1.
WARNING: the plug-in cards must be inserted and removed with
the power supply disconnected.
The storage module allows remote controls to be stored.
If the control panel is replaced, the BIXMR2 storage module being
BIXMR2 used can be inserted in the new control panel.
WARNING: the storage module must be inserted and removed with
the power supply disconnected.
Motor-encoder connection. Connect the motor and encoder to
the control panel by means of the supplied cables.
Battery operating. The batteries are ept charged when the power
supply is on. If the power supply is off, the control panel is powered
by the batteries until power is re-established or until the battery
voltage drops below the safety threshold. If this occurs, the control
BATK4
panel turns off.
WARNING: the batteries must always be connected to the control
panel for charging. eriodically check the ef ciency of the batteries.
NOTE: the operating temperature of the rechargeable batteries is
approximately +5°C/+40°C.
Description
ashing lights with 24
6
15 W bulbs can be