Operating Display Screens; Operating Status (Home) - Johnson Controls Frick QUANTUM LX Manual

090-022 O (NOV 09)
Page 8
ACCESSING:
DESCRIPTION: This is the default screen (also called the
most important information about the compressor and the applicable subsystems operation is displayed here. This screen is
shown when power is first turned on and when a key is pressed after the screen saver has turned off the backlight. The
Operating Status
screen is continuously updated and provides a variety of information with regard to the current condition
and performance of the compressor unit and subsystem.
The following information is shown on this screen:
DATE - The actual date will be displayed in this box.
The date must first be set correctly on the
Configuration screen. Once set, the date will be
automatically adjusted for at the end of each month,
much like the calendar feature of most modern
watches. The primary use of the date feature is to
provide a date stamp for Warnings and Shutdowns.
TIME
(See also )
TIME - The actual time will be displayed in this box.
The time must first be set correctly on the
Configuration
screen. The time will also need to be
adjusted for those locations which observe Daylight
Savings Time. The primary use of the time feature is
to provide a time stamp for Warnings and Shutdowns.
Date
(See also )
SCREEN TITLE - This is the title for the screen that is
showing. Each screen will have a title. The Quantum™
LX manuals will extensively refer to screens by these
names. When referred to in these manuals, screen
names will be shown in bold italic print, such as
Operating Status
.
FRICK ® QUANTUM™ LX COMPRESSOR CONTROL PANEL
OPERATION - SERVICE

OPERATING DISPLAY SCREENS

Operating Status (Home)

Home
Home
screen). When power is applied, this screen will appear. The
COMPRESSOR MODEL - This is actually a rotating
marquee. It will alternately display the model name of
the compressor (such as RWF) and will then rotate to
show Frick .
®
COMPRESSOR RUN STATUS -

Off

Running

Starting

Stopping

Stopping - High Capacity

Stopping - Pumpdown
PROCESS SETPOINT VALUE - This is the control
setpoint maintained by the internal capacity control.
PROCESS ACTUAL VALUE - The actual reading of the
pressure or temperature that was chosen as the
compressor control setpoint is shown here.
ID - The value shown here is the number that has
been assigned to this particular unit on the
Communications Setup
screen.