Ds30A Links; Ipe To Mctm, Mcrm, Mnet, And Mlnk - Nortel Meridian SuperNode SL-100 Reference Manual

DS30A links

The DS30A cable between the Meridian Cabinetized Trunk Module (MCTM)
and the IPEC must not be longer than 45 feet. The shield of the DS30A cable
is terminated at both ends by the connector hoods to the CHASGND (chassis
ground). For overhead cabling applications, a replacement rear grill must be
ordered. The Top Cap Rear Grill (PO699851) allows overhead cable entry to
the IPEC.

IPE to MCTM, MCRM, MNET, and MLNK

The IPE is connected to the Meridian Cabinet Trunk Module (MCTM) or
Meridian Cabinet Trunk Module ISDN (MCTM-I), Meridian Cabinet Remote
Module (MCRM) or Meridian Cabinet Remote Module Sonet (MCRM-S),
Meridian Network Controller Module (MNET), and Meridian Cabinet Link
Module (MLNK) by an NTNX36DR cable. One cable is required for two to
four links and two cables for five to six links. (MNET and MLNK cabinets
apply to the Meridian SL-100 Compact system.)
Note 1: MCTM, MCRM, MNET, and MLNK have been manufacture
discontinued but are still supported in the field.
Note 2: The Meridian Cabinetized Trunk Module ISDN (MCTM-I) will be
referred to as MCTM throughout the remainder of this document.
One cable is connected to connector J2 on the Electromagnetic Interference
(EMI) cable duct of the IPEC for each module and the second NTNX36DR
cable is connected to connector J3 on the bulkhead of the IPEC.
The NTNX36DR connects to the EMI cable ducts of the MCTM,
MCRM/MCRM-S, MNET, and MLNK cabinets, respectively.
The following table shows cable PEC and MCTM, MCRM, MNET, MLINK
connectivity for 6-port cables and bulkhead connections.
Table 4-10 Port Cables and Bulkhead Connections (Sheet 1 of 2)
Cable PEC
NTNX1750
NTNX3305
NTNX3307
NTNX3313
NTNX3314
NTNX3315
Meridian SuperNode MSL-100 Intelligent Peripheral Equipment (IPE) Reference Manual MSL14
Cabling specifications 4-15
Connector Designation
P00-P11
0P0
1P0
0P1
0P2
0P3