Pm180; Pm181 - Nortel Meridian SuperNode SL-100 Reference Manual

Instruction Pipe Stage C:
Instruction Pipe Stage B:
Data Cycle Fault Address:
Data Output Buffer:

PM180

Log PM180 is generated when a message is sent from the IPE to the CC
indicating a software exception has occurred.
The following is an example report format:
PM180 JAN01 17:44:11 2005 TBL PM EXCEPTION REPORT IPE HOST 00 3
MTCE:Illegal Destination Rcvd Exception Class:11

PM181

Log PM181 is generated when a diagnostic at the IPE fails, there is some
information about the IPE to be logged, or when changes occur to the line card
state.
PM 181 messages are also generated for the enhanced IPE controller
(EXPEC). Logs for the EXPEC are generated under the following
circumstances:
• when an MSL version message is sent to the IPE in association with a CM
RESTART, CM SWACT, and IPE RTS to the IPE
• when a time-of-day message is sent to the IPE in association with a CM
RSTART or IPE RTS
• when an IP address message is sent to the IPE in association with an IPE
RTS
The following is an example report format:
<Office ID> PM181 <mmmdd hh:mm:ss ssdd> INFO PM SW Information
Report IPE <Frame> <Shelf><text>
The following is an example log report:
RMSLDSNXAY
Node: InSv
RMSLDSNXAY
Node: InSv
RMSLDSNXAY
Node: InSv
Meridian SuperNode MSL-100 Intelligent Peripheral Equipment (IPE) Reference Manual MSL14
Information Byte:0D
PM181 AUG05 15:40:35 3000 INFO IPE IPE2 02 0
Time and Date was Successfully Sent.
PM181 AUG05 15:40:35 2900 INFO IPE IPE2 02 0
Set IPE MSL Version Succeeded
PM181 AUG05 15:40:34 2800 INFO IPE IPE2 02 0
Set IPE IP Port Info Succeeded
Log and fault reports 7-7
FDD8
4280
004018C9
0044D94B