Measurement Is Performed Via The Mes-Mode - Festo CP-AM-MEAS Original Operating Instructions

Operation

8.3.1 Measurement is performed via the MES-Mode

An example for a measurement in MES mode within the limit values
The carrier is transported into the CP application module Measuring. It runs through different working
procedures (see sequence description for the MES-Mode and sequence of steps). Afterwards the current
actual measured value of difference (3) is displayed. In our example, the measurement lies within the upper
and lower limit value, therefore the actual measured value of difference (3) is displayed in green color, and
the result (2) is also displayed in green color as "good". The signal lamp on the CP application module
Measuring is flashing green.
73
© Festo Didactic 8154245 en