Dmx Configuration; Dmx Addressing - ProLights EVO90F User Manual

12

3.8 DMX CONFIGURATION

EVO90F is equipped with different DMX configuration.
• Press the button MENU so many times until shows [SET], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [PERS], and press the button ENTER to confirm.
• Select the desired DMX configuration [UNO, DOS, STD.P] through the buttons UP and DOWN.
The tables on page 13 indicate the operating mode and DMX value. The EVO90F is equipped with 3/5-poles
XLR connections.

3.9 DMX ADDRESSING

• Press the button MENU so many times until the display shows [ADDR], and press the button ENTER to
confirm.
• Press UP/DOWN button to select the desired value (001-512).
• After the setting value is automatically saved.
To able to operate the EVO90F with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the EVO90F. The other functions of the light effect panel are then
automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of Start address
DMX channels
(example)
2 33
3 33
DMX Address: 33
DMX512 Controller
DMX Address Next possible start
occupied address for unit No. 1
33-34
33-35
DMX Address: 36
Example 3 DMX channels configuration (STD.P mode)
EVO90F
Next possible start
address for unit No. 2
35
36
DMX Address: 39
Next possible start
address for unit No. 3
37
39
DMX Address: 42
Fig.7
39
42
. . . . . . . . . . . .