Dimmer Mode; Special Functions - ProLights EVO90F User Manual

10

3.4 DIMMER MODE

This mode allows the user to manually control the intensity of the fixture:
• Press the button MENU so many times until shows [DIM], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [Fix c] then press ENTER to confirm.
• Using UP/DOWN button, select the desired value [d.000 - d.100]
• Press ENTER button to confirm.

3.5 SPECIAL FUNCTIONS

• Press the button MENU and select through the directional buttons the [SET] mode; and press the button
ENTER to confirm.
It is possible to view to following functions:
KEY
• Enter the [KEY] mode to select whether the access password is on or off.
• Select [ON] or [OFF].
When the fixture is set as pass [ON], after 30 seconds or turn on the fixture next time, the fixture will
need an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
DIM
Enter to [DIM] to select specific dimming curve. When dimmer is set to [OFF], the dimmer is linear.
DIM1/2/3/4 are speed modes of the linear dimmer; [DIM1] is the faster, while [DIM4] is the slowest.
CURV
Enter to [CURV] to adjust the shaèe of the dimming curve. See the CURV chart to understand more
about actual dimming curves:
CURV dimming
EVO90F
Fig.6
1: OFF
2: CV1
3: CV3
4: CV4