Table of Contents
Advertisement
Available languages
Available languages
• Press the button MENU so many times until the display shows [RUN], and press the button ENTER to
confirm.
• Press UP/DOWN to set the unit as [SLAVE].
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.6 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3 or 5 -pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.7 DMX CONFIGURATION
ARCLED3144RGBWA is equipped with 9 DMX configuration.
• Press the button MENU so many times until shows [PERSON], and press the button ENTER to confirm.
• Select the desired DMX configuration [TOUR - BLOCK1 - BLOCK2 - ARC1 - ARC1+D - ARC3 - ARC3+D - ARC3+S - HSV]
through the buttons UP/DOWN.
The tables on page 14 indicate the operating mode and DMX value. The ARCLED3144RGBWA is equipped
with 3 and 5 -pole XLR connections.
3.8 DMX MODE
• Press the button MENU so many times until the display shows [RUN], and press the button ENTER to
confirm.
• Press the buttons UP and DOWN to select [DMX] mode.
• Then enter the [ADDRESS] mode to set the ID address.
• Press the buttons UP and DOWN to select the desired value [001-512].
• After the setting value is automatically saved.
NOTE - When fixtures are under Auto program operation, the [RUN] mode does no works.
3.9 DMX ADDRESSING
To able to operate the ARCLED3144RGBWA with a light controller, adjust the DMX start address for the first
a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the ARCLED3144RGBWA. The other functions of the light effect
panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
Start address
DMX channels
(example)
9
33
12
33
ARCLED3144RGBWA
DMX Address
Next possible start
occupied
address for unit No. 1
33-41
33-45
Next possible start
address for unit No. 2
42
46
Next possible start
address for unit No. 3
51
61
11
60
76
Advertisement
Chapters
Table of Contents
