Installation Of The Telephone; Optional Connections - Atos Unify OpenScape CP710 Installation And Quick Reference Manual

Connect the Handset to the Telephone
See also overview on page 2.
1. Insert the plug on the long end of the handset cable
jack on the base of the telephone and press the cable into
G
the groove provided.
2. Insert the plug on the short end of the handset cable
the jack on the handset

Installation of the telephone

See also overview on page 2.
Desk Installation
By mounting the stands on the telephone using the long or
short end you can select between 22.5° and 45° tilt angle:
Long end: 22,5°
1. Place the phone upside down on a soft surface and remove all ca-
bles from the phone except the handset cord
2. Insert the stands on the base of the telephone as shown.
3. Slide the stands until it locks into place.
4. If your LAN does not have PoE (Power over Ethernet; ask
your administrator), then you need to use a power supply
connected to the power jack
5. Connect the LAN cable with the jack
the telephone and the wall jack.

Optional Connections

If desired, you can connect further devices to your phone (see
also overview on page 2):
Connection to PC
C
Connection to Headset
F
Connection to Key Module
E
If further settings are required for correct operation of the tele-
phone, please contact your administrator.
12
.
Short end: 45°
.
D
B
into the
into
.
on the base of