Using Sis Commands; Axp 64 C At-Initiated Messages; Sis Command Sets - Extron electronics AXP 64 C AT User Manual

3.
4.
5.
The AXP is ready to accept SIS commands immediately after it sends the copyright
message.

Using SIS Commands

AXP 64 C AT-initiated Messages
If the AXP 64 C AT is powered off, the PC is cabled to the AXP 64 C AT, and DataViewer is
set up and running on the PC, the connected AXP sends the following message when first
powered on:
© Copyright 20nn, Extron, AXP 64 C AT, Vn.nn, 60-1499-01
Vn.nn is the firmware version number.
No response is required from the host.

SIS Command Sets

Although the AXP 64 C AT uses the same structure for all SIS commands, three categories
of SIS commands are used with the AXP 64:
•
•
•
Although both types of commands use the same structure of basic SIS commands, they
differ in how the software addresses the individual processor blocks within the AXP 64 C AT.
On the Device Info screen, locate the name of your AXP. The IP address is in the
Primary Address column (see the example in figure 30,
Figure 30. AXP IP Addresses on the Dante Controller Device Info Screen
Connect the AXP to the control computer using a host communication utility such as
Extron DataViewer (available at no charge from www.extron.com).
Enter the IP address and port number (4333) into the control device or DataViewer. The
AXP 64 C AT responds with a copyright message, the name of the product, firmware
version, and part number (see
Basic global SIS commands (see
DSP SIS commands (see DSP SIS Commands
Digital I/O SIS commands (see
1
AXP 64 C AT-initiated Messages).
Basic SIS Commands
on page 34).
Digital I/O SIS Commands
AXP 64 C AT • SIS Configuration and Control
).
on the next page).
on page 42).
35