Audi TT 2007 Workshop Manual page 95

– Remove noise insulation (left-side) -arrows-.
– Remove bolts -arrows- and detach cover for gear oil pump
-A-, allowing remaining gear oil in cover to drain off into used
oil collection and extraction unit -V.A.G 1782- .
– Remove bolts -arrows- and detach cover for gear oil pump
-1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installing
• Tightening torques ⇒ page 80
Installation is carried out in reverse sequence; note the following:
Note
Renew bolts for gear oil pump and for cover for gear oil pump.
♦
Renew gasket -B- and cover for gear oil pump.
♦
– Check that dowel sleeves -C- are fitted in gearbox housing.
– Slide drive shaft -A- for gear oil pump into gearbox as far as
stop, turning shaft slightly as required.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
, ⇒ page 82
1. Oil pan, mechatronic unit, gear oil pump - exploded view
Audi TT 2007 ➤
91