Audi TT 2007 Workshop Manual page 55

– Remove bolts -1- and -2- and detach gearbox support -A-.
– Lower engine/gearbox assembly using spindle of support
bracket -10 - 222 A- until distance -a- is obtained between
gearbox housing and gearbox mounting.
• Dimension -a- = 100 ... 110 mm
To remove the direct shift gearbox 02E, set up gearbox support
-3282- with adjustment plate -3282/42A- and place on engine and
gearbox jack -V.A.G 1383 A- .
Note
The illustration shows a gearbox for a four-wheel drive vehicle;
however, the attachment points are the same for the front-wheel
drive version.
– Align arms of gearbox support according to holes in adjust‐
ment plate -3282/42A- .
– Secure support elements as illustrated on adjustment plate
-3282/42A- . However, use -retainer plate with drilling- as front
support element.
– Place engine and gearbox jack -V.A.G 1383 A- underneath
vehicle.
• The arrow symbol on the adjustment plate points in the direc‐
tion of travel.
– Align gearbox support -3282- parallel with gearbox.
– Screw pin -3282/29- into gearbox.
– Secure -retainer plate with drilling- firmly to gearbox as illus‐
trated -arrow-.
– Insert last support element in gearbox as illustrated.
– Support gearbox by lifting from underneath with engine and
gearbox jack -V.A.G 1383 A- .
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
51
4. Removing gearbox