Audi TT 2007 Workshop Manual page 26

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Place assembly sleeve -T10302- on a flat surface.
– The internal seal in the new clutch end cover must be pre-
formed before installation; this is done by guiding the clutch
end cover, with the outside downwards, horizontally and uni‐
formly over the assembly sleeve -T10302- .
– Lift assembly sleeve -T10302- out of clutch end cover.
– Fit assembly sleeve -T10302- over end of multiple clutch shaft.
Caution
Clutch end cover can be damaged.
♦ Do not attempt to drive on the clutch end cover with a
hammer.
– Guide clutch end cover with the outside upwards horizontally
over assembly sleeve -T10302- and press cover uniformly on‐
to its seat.
– If necessary use a screwdriver to lever the clutch end cover
carefully into its seat as illustrated -arrow- so that the corru‐
gated ring can be fitted.
– Install corrugated ring for clutch end cover in gearbox housing,
always holding the ring in place on the opposite side so that it
remains in its groove.
– Using a screwdriver, check that corrugated ring is fully engag‐
ed.
– Install gearbox ⇒ page 53
– Fill up with gear oil for direct shift gearbox
– Connect vehicle diagnostic, testing and information system -
VAS 5051B- .
– Perform basic setting.
22
Rep. Gr.30 - Clutch
.
⇒ page 72
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.