Audi TT 2007 Workshop Manual page 62

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Securing gearbox in horizontal position
– Secure gearbox to engine/gearbox support -VW 540-
-arrows-.
– Using workshop hoist -VAS 6100- , insert gearbox into support
clamp -VW 313- ⇒ page 56
WARNING
The gearbox can swing round suddenly in the support clamp.
♦ The centre of gravity of the gearbox is outside the pivot
centre of the support clamp. A second mechanic is there‐
fore required to hold the gearbox housing when the gear‐
box is rotated in the clamp.
Oil can escape when the gearbox is rotated in the support
clamp.
♦ The breathers on the gearbox housing must be sealed off
if the gearbox (with oil filling) is turned on the assembly
stand so that the oil pan faces upwards.
Securing gearbox in vertical position
– Secure gearbox to gearbox support -VW 353- and fit into sup‐
port clamp -VW 313- using support plate -VW 309- .
58
Rep. Gr.34 - Controls, housing
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.