Audi TT 2007 Workshop Manual page 58

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Carefully raise gearbox using engine and gearbox jack -V.A.G
1383 A- and position correctly using gearbox support -3282- .
Note
The illustration shows a gearbox for a four-wheel drive vehicle;
however, the attachment points are the same for the front-wheel
drive version.
– Join gearbox to engine, taking care not to trap wiring or other
connections.
– Secure gearbox to engine.
– Install assembly mountings (note correct sequence)
⇒ page 60 .
– Detach gearbox support -3282- from gearbox.
– Secure swivel joint (left-side) to wheel bearing housing ⇒ Rep.
Gr. 40 .
– Install flange shaft (right-side)
– Install drive shafts ⇒ Rep. Gr. 40 .
– Install heat shield for drive shaft (right-side).
– First secure pendulum support to gearbox -arrow B- and
-arrow C-, then on subframe -arrow A-. Tightening torques
⇒ page 59 .
– Install starter ⇒ Rep. Gr. 27 .
– Adjust assembly mountings ⇒ Rep. Gr. 10 .
– Tighten bolts -arrows- for assembly mounting (gearbox side).
– Detach support bracket -10 - 222 A- from engine.
54
Rep. Gr.34 - Controls, housing
⇒ page 95 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.