Audi TT 2007 Workshop Manual page 41

– Unplug electrical connector -3- from air mass meter -G70- .
– Release clamps -1 and 2- and disconnect air intake hose from
air mass meter -G70- .
– Unbolt front intake duct from lock carrier -4-.
– Remove engine cover panel.
– Detach locking plate -C-.
– Press retaining clip -A- upwards and detach.
– Press selector lever cable off selector shaft lever -arrow- and
pull out of support bracket -D-.
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not Do not bend or kink the selector lever cable.
♦
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-Items 1 and B- can be disregarded.
♦
– Remove Lambda probe after catalytic converter -G130- ⇒
Rep. Gr. 24 .
– Remove tunnel brace and bracket for exhaust system
-arrows-.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Audi TT 2007 ➤
3. Servicing selector mechanism - exploded view
37