Audi TT 2007 Workshop Manual page 16

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Component parts of dismantled multiple clutch
Caution
The clutch plates can slip out of position inside the multiple
clutch unit.
♦ This diagram showing the components of the multiple
clutch is for information only. The multiple clutch unit must
not be dismantled at present.
♦ If the drive plate becomes detached from the splines in the
outer plate carrier, the clutch plates can slip out of position
in the multiple clutch. It will then no longer be possible to
adjust the clutch correctly.
1 - Outer plate carrier with
clutch housing.
2 - Oil seals
❑ 4 x
3 - Inner plate carrier
Caution
The clutch plates can slip
out of position.
♦ If the inner plate carrier is
lifted or taken out, the
plates can slip out of po‐
sition inside the clutch. It
will then no longer be
possible to adjust the
clutch correctly.
4 - Outer plates
❑ 4 x
5 - Inner plates
❑ 4 x
6 - Thrust washer
7 - Circlip
❑ Fit a new circlip of the
same thickness if the
original circlip is re‐
moved in order to re-in‐
stall the clutch plates.
8 - Circlip
❑ Determining correct
thickness when instal‐
ling multiple clutch
⇒ page 18
9 - Drive plate
10 - Circlip
❑ Renew
12
Rep. Gr.30 - Clutch
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.