Audi TT 2007 Workshop Manual page 24

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Remove provisionally fitted circlip (2 mm) and fit new circlip
with thickness as calculated above.
Note
Circlips must not be used more than once.
♦
The removed (provisional) circlip and all remaining circlips
♦
should be disposed of.
– Install pump shaft. When installing, lift the shaft and turn it
slightly -arrow- so that it slides in and engages fully in the
splines.
– Install drive plate in multiple clutch.
• The projecting lug -arrow- on the drive plate must be posi‐
tioned between the colour-marked splines on the outer plate
carrier, or the marks made earlier in this procedure.
20
Rep. Gr.30 - Clutch
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.