gefran GFW 400A Installation And Operation Manual page 31

Figure 31 Example of GFW-2PH for 2 indipendent single phase loads
It is possible to connect two single-phase loads also to different line voltages, between line to line or line to neutral
It is possible to manage different power values for each one of the two loads.
(*)IMPORTANT:
Take care
to connect
terminals 1/L1
and 3/L1 to the
same phase
(**)Only required
with Vload
measurement
input option.
80999D_MHW_GFW 400-600A_07-2020_ENG
GFW Master - Dip-Switches Configuration
Dip 1 Dip 2 Dip 3 Dip 4
OFF OFF OFF OFF
V line voltage
P power of each single-phase load
Id load current if resistive load cosφ=1
FIRING MODE ZC, BF, HSC, PA
HB DIAGNOSTIC
Partial and total load failure pof each single leg
AVAILABLE
Fast Fuse Needed only for controller with option Fuse = 0
GG Fast Fuse See Fuse section
Dip 5
OFF
31