Planmeca Viso User Manual page 98

14 Help messages
Code
H141 Height movement
H142
H146
H147
H148
H149
H150
H151 Line voltage
H152
H153 Height movement
H154
H155
H156
H157
H158
H159
H160
94 Planmeca Viso
Explanation
Movement stopped because the
column is moving in wrong direction.
Height movement is not possible
because the stop plate at the bottom
of the column was activated.
Motor safety switch in upper
direction z drive
Motor safety switch in lower direction
z drive
Height movement is not possible.
The position of the patient support
base is too high.
Height movement was stopped
because the C-arm cannot be
moved higher.
Height movement was stopped
because the patient support base
cannot be moved lower.
The line voltage was too low during
exposure.
The line voltage is too low.
Z column is too high.
Z column is too low.
Imaging equipment is too high.
Imaging equipment is too low.
Imaging equipment movement
timeout.
Imaging equipment position sensor
not working properly.
Z column position sensor not
working properly.
Imaging equipment is moving in
wrong direction, check sensors and
cables.
Comments
The column is moving
in wrong direction, check
sensors and cables.
Clear any obstruction before
moving the column again.
Use the height adjusting
slider to move the patient
support base down.
Clear any obstruction before
continuing.
Clear any obstruction before
continuing.
Exposure was interrupted.
Contact your service
technician for help.
Exposure is not possible.
Contact your service
technician for help.
User's manual