Removing the power and volume-buttons
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
3. Remove the
coin-cell
battery.
Procedure
1. Peel off the tape that secures the power and volume-buttons board-cable to the palm-rest assembly.
2. Disconnect the power and volume-buttons board-cable from the I/O board.
3. Remove the power and volume-buttons board-cable from the routing guides on the palm-rest assembly.
4. Remove the screw (M2x3) that secures the power and volume-buttons board to the palm-rest assembly.
5. Lift the power and volume-buttons board off the palm-rest assembly.
42
Removing the power and volume-buttons board
computer. After working inside your computer, follow the instructions in
23
board
After
www.dell.com/